Reverse trigger mechanism suitable for R.A. spear-runs. Directly replaces existing mechanism.
High quality precision made mechanism, made of inox 316L Marine steel.
Easily installed: Simply take off old mechanism and snap the new one in, secure with existing pin.
7.5 cm linear load extension, due to back-end snap-in: Spear shaft snaps into back-end of mechanism, allowing for further load tension (7.5 cm), effecting in considerable increase of initial spear-shaft velocity, shooting range and piercing force.
Up to 180 kilos continuous trigger load, 360 kilos max load bench-tested! Certainly can “hold” a lot of rubber band pairs!
“Soft” trigger feel, steady fire with high lever ratio.
Auto release cord hook included.
MVD quality control passed.
Limited life time warranty.
V1 (no loading butt)
V2 (with loading butt)
Please note that Freediving and spearfishing are inherently dangerous sports and should only be undertaken by experienced, well-trained divers. More powerful spearguns must be fired with two hands and a locked elbow to prevent injury from excess recoil. Do not load or unload your speargun out of the water, treat every speargun as if it were loaded. Never point your speargun at anything you do not intend to shoot. Before you begin your dive, be sure to check all your gear. You should never dive alone and your equipment should be serviced regularly. You should always plan your dive and dive your plan. You should discuss safety precautions, your plan, and contingency plans with everyone onboard BEFORE you dive. Communication among divers and operators is imperative. Failure to adhere to these guidelines could potentially result in physical harm or death. Blue Tuna Spearfishing is not responsible for any loss, damage, harm, or death caused by using any of our products.
©2007-2017 Blue Tuna Spearfishing. All rights reserved.